Zhejiang Delong Teflon And Plastic Technology Co.,Ltd
Hot Products
Home > News > Content

What Insert Radiator Production Process Procedures Are?

First, the density ratio of the teeth and the tongue mold in test mode when the first branch of the rod must be 150-200mm short rod or a rod.

Second, before the tryout, you must adjust the center of the extrusion, extrusion axis, Sheng ingot mold base tube and spout must be on a center line.

Third, in the test mode and normal production process, the aluminum rod heating temperature should be between 480-520 ℃.

Four, according to a conventional mold heating temperature of the mold temperature should be controlled at about 480 ℃, diameter of 200mm or less flat die capable of holding time is not less than 2 hours, if the split mold should be kept at least 3 hours; more than 200mm diameter the mold should be incubated for 4-6 hours to ensure the core temperature of the mold should be uniform and the outside temperature.

Fifth, before tryout or production, you must use clean clear cylinder head gasket cylinder liner containing ingot, and also view the extruder empty running correctly.

  • Company Profile
    DELONG is one of the top level China ptfe tube manufacturers and suppliers, as a professional exporter with productive factory, we are able to provide virgin and white insolution and lubricate ptfe tube, hdpe sheet, ptfe filled, ptfe film, ptfe hose, ptfe membrane, teflon board, teflon pipe, teflon sheet products with low price and good quality. Welcome to buy cheap products from us....
  • Product Category
  • Contact Us
    Address:No.269 Zishan Road, Wukang Economic Development Zone,Deqing County, Huzhou City, Zhejiang Province, China
    Tel: +86-572-8837389
    Fax: 86-572-8837089